Inserting The Tgm550, Tims, And New Pims Into The Chassis - Avaya IG550 Installing And Configuring

Inserting the TGM550, TIMs, and new PIMs into the chassis

!
CAUTION:
Neither the TIMs nor the TGM550 should be inserted into the J-series router
CAUTION:
before you are sure the router is running release 8.2 or higher. Failure to comply
with this caution may cause your system to become inoperable.
!
CAUTION:
If the Communication Manager media server is already administered for the slots,
CAUTION:
the slots in which you insert the equipment must match exactly how the slots are
administered on the Media Gateway screen in Communication Manager.
!
CAUTION:
The router must be turned off before inserting or removing the Avaya TGM550
CAUTION:
and TIM modules. These modules are not hot-swappable. If you attempt to
remove or insert these modules while the router is turned on, the router might
reset or malfunction in some other way.
1. Determine the slots in which to insert the TGM550 and the TIMs.The TGM550 and TIMs
can reside in any of the six slots. None of the slots is restricted from housing the TGM550 or
any particular model of TIM.
2. Ensure power is turned off.
3. Insert the TGM550 and each TIM into the correct slot.
4. Align the notches in the connector at the rear of the TGM550, TIM, or PIM with the notches
in the slot in the router. Then slide the module in until it lodges firmly in the router.
!
CAUTION:
Carefully slide the module straight into the slot to avoid damaging the connector
CAUTION:
components.
5. Drive the screws to hold the module in place.
Issue 1.1 May 2007 101