Preparing installation worksheets
Before you perform the upgrade, enter the names of the target software and firmware versions
that you need to install in the software and firmware upgrade worksheet. See
firmware upgrade files for upgrade
If you will need to set up a TFTP server, you also need to plan the TFTP server IP address,
login and password. Enter these values in the TFTP Server Values worksheet. See
values
on page 75.
Software and firmware upgrade files for upgrade
Enter software and firmware upgrade file names in the following table:
Table 4: Software and firmware upgrade file names
Items for Upgrading
Files for LSP and primary controller (not used with
Gateway Installation Wizard or for individual files)
G250 Processor
TFTP server values
Enter the TFTP server information in the following table:
Setting up a TFTP server
To load individual firmware files on an Avaya G250 Media Gateway, you must place the files on
a PC connected to the customer's LAN or on an S8300 Server in the customer's network. Later,
you will log onto the G250 and use its TFTP capability to download the new firmware. If you can
use an S8300 Server to stage the firmware, see
S8300 Server
on page 77. If not, a TFTP server must be set up on the LAN.
Upgrading G250 firmware using the CLI via FTP/TFTP
on page 75.
Table 5: Global Settings for TFTP Server
TFTP Server IP
Address
New file name for target
TFTP Server
Directory
Installing firmware from the TFTP server on the
Issue 6 November 2009
Software and
TFTP server
75