Upgrading The S8300A; Installing The Pre-Upgrade Software Service Pack, If Necessary - Avaya G700 Installing Manual

Upgrading the S8300A

!
CAUTION:
This upgrade procedure, including remastering the hard drive on the S8300,
CAUTION:
requires a service interruption of approximately 4 hours, or up to 6 hours if IA770
is being used.
This section describes the procedures for upgrading the S8300A Media Server from a pre-3.0
release of Communication manager to release 3.1.
Upgrading an S8300 to release 3.1 requires removing the S8300A and replacing it with an
S8300B. The new S8300B should have the remastering program (RP) software installed on its
hard drive. The remastering program remasters the hard drive and installs the R 3.1
Communications Manager software. These procedures are described in this section.
This section covers:

Installing the pre-upgrade software service pack, if necessary

●
Linux migration backup (if current release is 1.2.0 through 1.3.x)
●
Replacing the S8300A with the S8300B Media Server
●
Upgrading Communication Manager software
●
Installing the pre-upgrade software service pack, if necessary
A pre-upgrade service pack is required only if the current software is between 1.2.0 and 1.3.0.
If the current software release is between 1.1.0 and 1.1.9, or between 2.0.0 and 2.0.9, skip this
service pack installation procedure and go to
Server on page 257.
If the current software release is 1.3.1, skip this service pack installation procedure and go to
Linux migration backup (if current release is 1.2.0 through 1.3.x)
Note:
Typically, any existing service packs should be removed before installing a new
Note:
service pack. However, removing existing service packs is not necessary for this
procedure.
on page 257
on page 258
Replacing the S8300A with the S8300B Media
on page 254.
Upgrading the S8300A
on page 251
on page 254
Issue 9.1 June 2006 251