Configuring Gts; Configuration Procedure; Configuration Example; Configuring The Line Rate - H3C S5120-EI Series Operation Manual

Configuring GTS

Configuration Procedure

On the S5120-EI series, traffic shaping is implemented as queue-based GTS, that is, configuring GTS
parameters for packets of a certain queue.
Follow these steps to configure queue-based GTS:
To do...
Enter system view
Enter
Enter
interface
interface
view
view or
port
Enter port
group
group
view
view
Configure GTS for a
queue
Display interface GTS
configuration
information

Configuration Example

Configure GTS on GigabitEthernet1/0/1, shaping the packets of queue 1 when the sending rate
exceeds 512 kbps.
# Enter system view.
<Sysname> system-view
# Enter interface view.
[Sysname] interface gigabitethernet 1/0/1
# Configure GTS parameters.
[Sysname-GigabitEthernet1/0/1] qos gts queue 1 cir 512

Configuring the Line Rate

Configuration Procedure
Follow these steps to configure the line rate:
To do...
Enter system view
Enter
Enter
interface
interface
view
view or
Enter port
port group
group
view
view
Use the command...
system-view
interface interface-type
interface-number
port-group manual port-group-name
qos gts queue queue-number cir
committed-information-rate [ cbs
committed-burst-size ]
display qos gts interface
[ interface-type interface-number ]
Use the command...
system-view
interface interface-type
interface-number
port-group manual port-group-name
4-6
Remarks
—
Use either command
Settings in interface view take
effect on the current interface;
settings in port group view take
effect on all ports in the port
group.
Required
Available in any view
Remarks
—
Use either command
Settings in interface view take
effect on the current interface;
settings in port group view take
effect on all ports in the port
group.