Clearing The Syslog Messages From The Local Buffer; Displaying Tcp/Udp Port Numbers In Syslog Messages - Dell PowerConnect B-RX Configuration Manual

Static Log Buffer:
Dec 15 19:04:14:A:Fan 1, fan on right connector, failed
Dynamic Log Buffer (50 entries):
Dec 15 18:46:17:I:Interface ethernet Lab2, state up
Dec 15 18:45:15:I:Warm start

Clearing the Syslog messages from the local buffer

To clear the Syslog messages stored in the BigIron RX's local buffer, use the following command.
BigIron RX# clear logging
Syntax: clear logging

Displaying TCP/UDP port numbers in Syslog messages

The command ip show-acl-service-number allows you to change the display of TCP/UDP application
information from the TCP/UDP well-known port name to the TCP/UDP port number. For example,
entering the following command causes the BigIron RX to display http (the well-known port name)
instead of 80 (the port number) in the output of show commands, and other commands that
contain application port information. By default, the BigIron RX displays TCP/UDP application
information in named notation.
In this release, you can display TCP/UDP port number instead of their names in syslog messages by
entering the following command.
BigIron(config)# ip show-service-number-in-log
Syntax: [no]ip show-service-number-in-log
Syslog messages
Table 222
following order:
•
•
•
•
•
•
•
•
BigIron RX Series Configuration Guide
53-1001810-01
lists all of the Syslog messages. The messages are listed by message level, in the
Emergencies (none)
Alerts
Critical
Errors
Warnings
Notifications
Informational
Debugging
A
Syslog messages
1281