Configuring A C3000 Fax Server - Avaya IP Office Voicemail Pro Installation And Maintenance Manual

Voicemail Pro Installation and Maintenance Guide
3. Set up the incoming DDI routing of calls to specific users as required.

Tip
If the fax board can support multiple lines, you can configure them as a group (set to Hunt or
Rotary). The group number can then be used as the fax destination instead of an individual
extension number.
The next step is to set the Voicemail Pro system fax number. For more information, see Setting
the Voicemail Pro System Fax Number.

Configuring a C3000 Fax Server

This section explains how to configure a C3000 fax server to work with Voicemail Pro. Currently this type
of fax server is used only in Germany.
The information provided here assumes that:

The C3000 fax server software is installed

The Exchange Connector is installed and configured.
For information about system requirements (hardware and software) and how to install the Exchange
Connector, refer to the C3000 Installation Manual.
Configuring a C3000 fax server to work with Voicemail Pro involves the following key steps:
1. Set up an IP line so that the fax server can receive faxes from the IP Office. For more
information, see Setting up an IP Networking Gateway Line
2. Set up the routing for incoming calls for each line group. For more information, see Setting up
Incoming Call Routes.
3. Set up the least cost routing with a short code. For more information, see Setting Up a Short
Code for Routing Faxes to Prefixed Numbers.
4. Configure XCAPI settings. For more information, refer to the C3000 Installation Manual and the
C3000 Administration Manual.
Page 200
15-601063 Issue 15b (31 May 2006)
Voicemail Pro Installation and Maintenance Guide
IP Office