Configuring Individual Device Paths; Configuring Lun Masking For This Host - Qlogic SANsurfer FC HBA Manager Application User Manual

Q
7.4.1.2

Configuring Individual Device Paths

Perform the following steps to set device path visibility to the operating system.
NOTE:
1. From the Fibre Channel Port Configuration dialog box, right-click in the cell
in the HBA Port n column.
2. From the pop-up menu, select one of the available options:
❑
❑
3. If setting the path has caused the LUNs associated with this device to have an
invalid configuration, the modify LUN configuration message displays. When
the problem occurs, it usually results from changing a device to or from the
unconfigured state. You need to modify the LUN configuration for this device
before the configuration can be saved or applied. Click OK.
7.4.2

Configuring LUN Masking for this Host

You can configure LUN masking—set LUNs as masked or unmasked from the
operating system. Enabling a LUN sets the LUN as unmasked; disabling a LUN
sets the LUN as masked.
Use the following options as appropriate:
Enabling and disabling all LUNs
■
Configuring LUN paths and LUN masking for a device
■
FS0054603-00 C
There must be one visible path for the operating system to see the device.
Select Set Visible to set this path as visible by the operating system during
the boot process.
Select Set Unconfigured to set this path as not visible by the operating
system.
7 – Setting Up Connections
Configuring Fibre Channel Devices
(see section 7.4.2.1)
(see section 7.5)
7-31