Specifying The Polling Interval; Polling Setting Dialog Box - Qlogic SANsurfer FC HBA Manager Application User Manual

Q
6.8

Specifying the Polling Interval

The polling interval is set on a host basis. The polling interval is the length of time
between polls to a connected host to retrieve information. The SANsurfer FC HBA
Manager main window HBA tree refreshes automatically based on this rate.
NOTE:
Perform the following steps to set a host's polling interval:
1. In the SANsurfer FC HBA Manager main window HBA tree, select the host (or
HBA, HBA port, device, or LUN connected to the host) for which you want to
set the host's polling interval.
2. Do one of the following:
❑
❑
3. The Polling Setting dialog box displays
displays in the title bar.
4. In the Interval box, type the polling interval. The range is 1 second to
3600 seconds (1 hour). The default is 30 seconds.
NOTE:
5. Click OK to set the interval. Click Cancel to not change the interval setting.
FS0054603-00 C
If you want to update the HBA tree immediately, click the Refresh button
on the toolbar.
From the Host menu, select Polling.
Right-click the selected host (or HBA, HBA port, device, or LUN connected
to the host) in the HBA tree. From the pop-up menu, select Polling.
Figure 6-8. Polling Setting Dialog Box
The faster the polling rate, the more quickly the SANsurfer FC HBA
Manager GUI receives indications from the connected host.
However, faster polling rates consume more of your system's CPU
and network resources and slow the system.
6 – Getting Started
Specifying the Polling Interval
(see figure 6-8). The name of the host
6-13