Q
4. In the Notification Options section, do the following:
a. Select the check boxes for the alarm notifications that you want to send. For
b. If you want to send the current host configuration, select the Attach Host
5. To enable email notification, select the Enable Alarm Notifications over Email
check box.
6. Click Test to verify that email notification is operable. If successful, a message
displays stating that the email was sent successfully. Check the email
addresses for the email.
7. Click OK to accept your modifications. Click Cancel to not modify the email
notification settings.
6.12
Specifying the HBA Driver Settings
Setting the HBA driver parameters involves specifying the following:
Group Persistent. Whether only targets configured using SANsurfer FC HBA
■
Manager are seen by the system
Group Binding. Whether the driver binds the target ID using the target's world
■
wide port name (WWPN) or port ID
FS0054603-00 C
detailed information about alarms,
Information Alarms check box
❑
Unknown Alarms check box
❑
Warning Alarms check box
❑
Bad Alarms check box
❑
Configuration check box.
Specifying the HBA Driver Settings
see section
8.2.1.
6 – Getting Started
6-17