Preparing For Normal Hba Operations; Data Miscompare Results - Qlogic SANsurfer FC HBA Manager Application User Manual

10 – Performing Diagnostics

Preparing for Normal HBA Operations

R/W buffer not supported
❑
Write buffer failed
❑
Link Failure. Number of link failures
■
Sync Loss. Number of sync loss errors
■
Signal Loss. Number of signal loss errors
■
Invalid CRC. Number of invalid CRCs
■
If the value in the Data Miscompare column is nonzero, you can view the
miscompare information by double-clicking any column. The Diagnostic Details
dialog box displays
Do the following as appropriate:
Click Next to view the details of the next miscompare.
■
Click Previous to view the details of the previous miscompare.
■
Click Close to return to the Diagnostics tabbed page.
■
10.5
Preparing for Normal HBA Operations
When loopback testing is complete, do the following to resume normal HBA
operations:
1. Do the following to remove the loopback connector:
a. Remove the loopback connector from the HBA connector.
b. Reconnect the cable that you disconnected in
2. Modify the HBA settings Connection Options back to its previous setting
section
10-12
(see figure 10-5).
Figure 10-5. Data Miscompare Results
10.1.2.1).
Q
section 10.1.2.2.
FS0054603-00 C
(see