Qlogic SANsurfer FC HBA Manager Application User Manual page 97

Q
❑
❑
❑
❑
3. The modified configuration set up by SANsurfer FC HBA Manager can be either
applied to the live system for dynamic updates or saved to the system's
persistent configuration data. If the configuration is saved, the HBA's driver
retrieves the data from the persistent configuration data at the next system
bootup and configures the system accordingly.
NOTE:
Do one of the following:
❑
❑
FS0054603-00 C
Bind target devices attached to the HBA port
Delete persistent configuration data for an HBA port or device
section 7.9).
View information (see section
HBA port information
❑
Device information
❑
Get help. From the Help menu, click Browse Contents. The help text for
the Fibre Channel Port Configuration dialog box displays.
Some older versions of the drivers do not support persistent
configuration data and the application does not save persistent
configuration entries for these drivers.
Click Save to save the new configuration. The new configuration is saved
to the persistent configuration data so that it will be used the next time the
system is rebooted. The current boot configuration remains in memory and
redisplays after the save operation completes.
The following messages can display:
If the save was successful, the configuration saved—must reboot
❑
message displays. Click OK. Reboot the system that you configured to
display the new configuration.
If the save failed, the save configuration failed message displays. The
❑
failure is usually caused by communication problems between the GUI
and agent. Click OK.
Click Cancel to not save the configuration changes.
Configuring Fibre Channel Devices
7.6):
(see section 7.6.1)
(see section 7.6.2)
7 – Setting Up Connections
(see section 7.7)
(see
7-29