Q
Perform the following steps to modify the settings for the selected HBA ports:
1. In the SANsurfer FC HBA Manager main window HBA tree, select the HBA port.
If you want to configure multiple HBA ports with the same settings, hold the
CTRL key while selecting multiple HBA ports. The HBA ports must be in the
same series (QLA23xx HBAs, QLA22xx HBAs, or QLA200 HBAs). When you
select multiple HBA ports, the HBA Port Selection drop-down box displays
(see figure
Figure 11-2. Settings Tabbed Page—Multiple HBA Ports Selected
NOTE:
2. Select the Settings tab.
3. In the Select Settings section box, select the type of settings that you want
to modify.
❑
❑
❑
4. As appropriate, modify the settings. In the list boxes, type or select the setting.
Select or clear the check boxes.
FS0054603-00 C
Updating the HBA Port Settings, Advanced HBA Port Settings, and Boot Device
11-2).
Only the Settings (HBA Port Settings and Advanced HBA Port
Settings) and Utilities tabbed pages can be configured for multiple
HBA ports; therefore, the remaining tabbed pages do not display
when multiple HBA ports are selected.
HBA Port Settings. See
Advanced HBA Port Settings. See
Boot Device Selection. See
section 11.1.1
for details.
section 11.1.2
section 11.1.3
for details.
11 – Updating the HBA
for details.
11-3