Displaying Debug Information - Extreme Networks ExtremeWare XOS Guide Manual

will be similar to the following:
Comp SubComp
------- ----------- ----------------------- ------------- --------
STP InBPDU
Occurred : # of times this event has occurred since last clear or reboot
Flags : (*) Not all applications responded in time with there count values
In(cluded): Set to Y(es) if one or more targets filter includes this event
Notified : # of times this event has occurred when 'Included' was Y(es)

Displaying Debug Information

By default, a switch will not generate events of severity
unless the switch is in debug mode. Debug mode causes a performance penalty, so it
Debug-Data
should only be enabled for specific cases where it is needed. To place the switch in debug mode, use the
following command:
enable log debug-mode
After debug mode has been enabled, any filters configured for your targets will still affect which
messages are passed on or blocked.
ExtremeWare XOS 10.1 Concepts Guide
Condition
Drop
Severity Occurred
Error
,
Debug-Summary Debug-Verbose
Event Management System/Logging
In Notified
-- --------
0 Y 0
, and
111