Dell Networking 7048 Reference Manual page 131

Command
ip pim ssm
show ip multicast
show ip mcast boundary
show ip multicast interface
show ip mcast mroute
show ip mcast mroute group
show ip mcast mroute
source
show ip mcast mroute static
show ip pim bsr-router
show ip pim interface
show ip pim neighbor
show ip pim rp hash
show ip pim rp mapping
a. For the meaning of each Mode abbreviation, see
Description
Administratively configures PIM Source
Specific Multicast (SSM) range of addresses for
IP multicast routing.
Displays the system-wide multicast
information.
Displays the system-wide multicast
information.
Displays the multicast information for the
specified interface.
Displays a summary or all the details of the
multicast table.
Displays the multicast configuration settings of
entries in the multicast mroute table.
Displays the multicast configuration settings of
entries in the multicast mroute table.
Displays all the static routes configured in the
static mcast table.
Displays the bootstrap router (BSR)
information.
Displays PIM interface status parameters. If no
interface is specified, the command displays the
status parameters of all PIM-enabled interfaces.
Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
Displays the rendezvous point (RP) selected for
the specified group address.
Displays the mappings for the PIM group to the
active rendezvous points (RPs).
Mode Types on page 81.
Command Groups
a
Mode
GC
PE
PE
PE
PE
PE
PE
PE
PE
UE or
PE
UE or
PE
UE or
PE
UE or
PE
131