Utility Commands - Dell Networking 7048 Reference Manual

Command
ip vrrp accept-mode
show ip vrrp interface
a. For the meaning of each Mode abbreviation, see

Utility Commands

Auto-Install
Command
boot auto-copy-sw
boot auto-copy-sw allow-
downgrade
boot host autoreboot
boot host autosave
boot host dhcp
boot host retrycount
show auto-copy-sw
show boot
a. For the meaning of each Mode abbreviation, see
Description
Enables the VRRP Master to accept ping
packets sent to one of the virtual router's IP
addresses.
Displays the configured value for Accept Mode. UE or
Mode Types
Description
Enables or disables Stack Firmware
Synchronization.
Enables downgrading the firmware version on
the stack member if the firmware version on the
manager is older than the firmware version on
the member.
Enables rebooting the device (no administrative
intervention) when the auto-image is
successfully downloaded.
Enables/disables automatically saving the
downloaded configuration on the switch.
Enables/disables Auto Config on the switch.
Set the number of attempts to download a
configuration.
Displays Stack Firmware Synchronization
configuration status.
Displays the current status of the Auto Config
process.
Mode Types
on page 81.
on page 81.
Command Groups
a
Mode
IC
PE
a
Mode
GC
GC
GC
GC
GC
GC
PE
PE
145