Dell Networking 7048 Reference Manual page 197

Example Session
This section describes an Easy Setup Wizard session. Refer to the state
diagram in the previous section for general flow. The following values used by
the example session are not the only possible ones:
• IP address for the VLAN 1 is 192.168.1.2:255.255.255.0. This address is on
a different subnet than the OOB interface and in the same subnet as the
default gateway.
• The user name is
length (admin123).
• The network management system IP address is 192.168.2.1.
• The default gateway is 0.0.0.0.
• The SNMP community string to be used is
The setup wizard configures the initial values as defined above. After the user
completes the wizard, the system is configured as follows:
• SNMPv1/2c is enabled and the community string is set up as defined
above. SNMPv3 is disabled.
• The admin user account is set up as defined.
• The address of the network management station is configured. From this
management station, the user can access the SNMP, HTTP, and CLI
interfaces. The user may also choose to allow all IP addresses to access
switch management by choosing the (0.0.0.0) IP address.
• An IP address is configured for the default VLAN (1).
• A default gateway address is configured.
The following example contains the sequence of prompts and responses
associated with running an example Dell Easy Setup Wizard session, using
the input values listed above. Note in this case a static IP address for the
management interface is being set up. However it may be requested that the
system automatically retrieve an IP address via DHCP . If DHCP is used, the
system does not request a network mask or default gateway. In this example,
the user employs the setup wizard to configure the initial values as defined
above.
admin , and the password should be 8-64 characters in
public .
Using the CLI
197