Dell Networking 7048 Reference Manual page 139

Command
distance ospf
enable
exit-overflow-interval
external-lsdb-limit
ipv6 ospf
ipv6 ospf area
ipv6 ospf cost
ipv6 ospf dead-interval
ipv6 ospf hello-interval
ipv6 ospf mtu-ignore
ipv6 ospf network
ipv6 ospf priority
ipv6 ospf retransmit-
interval
ipv6 ospf transmit-delay
ipv6 router ospf
maximum-paths
nsf
nsf helper
Description
Sets the route preference value of OSPF in the
router.
Resets the default administrative mode of OSPF
in the router (active).
Configures the exit overflow interval for OSPF.
Configures the external LSDB limit for OSPF.
Enables OSPF on a router interface or loopback
interface.
Sets the OSPF area to which the specified router
interface belongs.
Configures the cost on an OSPF interface.
Sets the OSPF dead interval for the specified
interface.
Sets the OSPF hello interval for the specified
interface.
Disables OSPF maximum transmission unit
(MTU) mismatch detection.
Changes the default OSPF network type for the
interface.
Sets the OSPF priority for the specified router
interface.
Sets the OSPF retransmit interval for the
specified interface.
Sets the OSPF Transmit Delay for the specified
interface.
Enters Router OSPFv3 Configuration mode.
Sets the number of paths that OSPF can report
for a given destination.
Enables OSPF graceful restart.
Allows OSPF to act as a helpful neighbor for a
restarting router.
Command Groups
a
Mode
ROSV3
ROSV3
ROSV3
ROSV3
IC
IC
IC
IC
IC
IC
IC
IC
IC
IC
GC
ROSV3
ROSV3
ROSV3
139