Dell Networking 7048 Reference Manual page 155

power inline detection
power inline high-power
power inline limit
power inline management
power inline powered-
device
power inline priority
power inline priority enable
power inline reset
power inline usage-
threshold
clear power inline statistics
show power inline
show power inline
firmware-version
a. For the meaning of each Mode abbreviation, see
RMON
Command
rmon alarm
rmon collection history
rmon event
show rmon alarm
Configures the detection type that tells
which types of PD's will be detected and
powered by the switch.
Configures the port high power mode.
Configures the type of power limit.
Sets the power management type.
Adds a comment or description of the
powered device type.
Configures the port priority level for the
delivery of power to an attached device.
Use this command along with the power
inline management command for power
management.
Use to reset the port.
Configures the system power usage
threshold level at which lower priority
ports are disconnected.
Clears the PoE statistics.
Reports current PoE configuration and
status.
Displays the version of the PoE controller
firmware present on the switch file system.
Mode Types
Description
Configures alarm conditions.
Enables a Remote Monitoring (RMON) MIB
history statistics group on an interface.
Configures an RMON event.
Displays alarm configurations.
IC
IC
IC
GC
IC
(Ethernet)
IC
(Ethernet)
GC
IC
GC
PE
PE
PE
on page 81.
Command Groups
a
Mode
GC
IC
GC
UE
155