Deskside Cabinet Cabling - HP Surestore Disk Array 12h - And FC60 Service Manual

Appendix C. Cabinet Configurations

Deskside Cabinet Cabling

Deskside Cabinet Cabling
To attach the power and SCSI cables to the deskside cabinet, perform the following steps:
1. If present, remove the rear door (7) from the deskside cabinet as shown in
2. Connect the SCSI cables (1) and route them through the hook and loop strap (5) on the left rear of the
cabinet.
3. Connect the short SCSI cable (2) if necessary. Refer to "Connecting SCSI Cabling" in the Chapter
"Product Description" for more details about SCSI cabling.
4. Connect the power cords (6) to the disk array and route them through the hook and loop strap on the
right rear of the cabinet.
5. Reinstall the rear door onto the deskside cabinet.
6. Attach the front door of the disk array as shown in
7. To keep the deskside cabinet from rolling, unscrew the four leveling feet on the bottom four corners of
the deskside cabinet until they touch the floor.
228
Figure
Figure 40. Deskside Cabinet Cabling
Figure 40.
45.