HP Surestore Disk Array 12h - And FC60 Service Manual page 126

Troubleshooting
Control Panel Error Messages
Table 11. Control Panel Error Messages (Disk States)
Error Message
Disk States: Log information is being logged on the
Current Log Disk specified log disk.
Disk States: The disk module is in a Not Included state.
Downed
Disk States: The disk module is in a failed state.
Failed
Disk States: The disk module failed during initialization.
Failed Setup
Disk States: The log disk has failed.
Log Disk Failed
Disk States: The log disk is full and ready to be evaluated.
Log Disk Full
Disk States: The disk module is not part of a logical drive.
Not Included Auto Include is OFF.
Disk States: The disk module has been used in a different
Previously Used array.
Disk States: The disk module is in a ready state.
Ready
Disk States: The disk module is in an unknown or
Unknown unexpected state.
Disk States: This type of disk module is unsupported and
Unsupported has not been tested.
Disk States: More than one log disk is installed. This log
Unused Log Disk disk will not be used.
126
Explanation Action
None. Information only.
The user requested the array to enter this state.
Use the Include Disk command if you want to
include the disk module.
Replace the disk module.
Replace the disk module.
Return the log disk to the factory for a
replacement.
Return the log disk to the factory for an
evaluation of the log.
You must manually include the disk module to
make it become part of the logical drive set.
None. Information only.
CAUTION: The disk module may be used in
the present array, but the original data will
be lost when Include Disk is executed.
None. Information only.
Call the support line and remove the disk
module.
CAUTION: Replace the disk module with one
that is supported. Inclusion of this disk module
may cause unpredictable results or loss of data.
None. Information only.