Installing The Disk Array Into The Deskside Cabinet - HP Surestore Disk Array 12h - And FC60 Service Manual

Appendix C. Cabinet Configurations

Installing the Disk Array into the Deskside Cabinet

Installing the Disk Array into the Deskside Cabinet
If the disk array is already installed into the deskside cabinet, skip this set of steps. To install the disk array
into the deskside cabinet, see
1. Attach the edge protector (5) along the lower front of the cabinet as shown in
protect the cabinet from being scratched when installing the disk array enclosure.
2. Install the four provided clip nuts (6) onto the front of the deskside cabinet as shown in
3. Lift the disk array enclosure into the cabinet, and secure it with the four screws (4) as shown in
39. Remove the edge protector.
4. Loosen the two screws on the clamp (7) at the rear of the deskside cabinet, and slide the clamp forward
until the tabs of the clamp engage in the slots in the lower rear corners of the disk array as shown in
Figure 39.
5. Loosen the two screws on the clamp at the rear of the deskside cabinet, and slide the clamp forward
until the tabs of the clamp engage in the slots in the lower rear corners of the disk array as shown in
Figure 39. Retighten the two screws.
6. Install the disk array door (3) as shown in
7. Proceed to the next section to install the cabling.
226
Figure 39 and perform the following steps:
Figure 45.
Figure 39. This will
Figure 39.
Figure