Installing The Disk Array Into A Rack - HP Surestore Disk Array 12h - And FC60 Service Manual

Appendix C. Cabinet Configurations
Rackmount Cabinets

Installing the Disk Array into a Rack

1. Install one clip nut (Figure
rails (2) with four 5 screws (3). See
T-2
arrays. (This spacing begins installation by installing an array in the lowest cabinet, EIA, position.)
2. Install two clip nuts on the front left and two on the front right ear standards; one clip nut
Item 4) on hole number 7 and one clip nut (5) on hole number 33. See
nut spacing for multiple disk arrays.
3. Slide the enclosure into the cabinet (see
4. Slip the Retainer Clip
with retainer clip screw.
5. Install the door snap (see
guide. Secure the door snap with one T-15 screw (4).
6. Install the enclosure door (see
hinge bracket pin (2) then swing the upper corner mounting slot into the upper hinge bracket pin (3).
Gently press on the upper left corner of the door and snap the upper corner onto the hinge bracket.
7. Repeat steps 1 through 6 to install additional disk arrays.
8. Install two filler panels in the top two EIA slots (see
9. Connect the disk array power cords (see
10. Press the cabinet power switch (see
power light (2) should be green.
NOTE! For greater power redundancy, you can connect each power module into a separate
PDU. This will require ordering the Power Upgrade Kit A4915A to obtain additional PDUs, refer to
Appendix D for additional information.
CAUTION! To prevent the current rating of the PDU from being exceeded, observe the
maximum current rating of the PDU. Do not connect more enclosures than the PDU rating.
You may have to upgrade your PDU to provide enough total current for a full back-to-back
rack configuration.
230
42, Item 1) on each of the four rail standards on hole number 3. Secure the
Table 18 for rail standard clip nut spacing for multiple disk
Figure 43). Secure the enclosure with four T-25 screws.
(Figure 41 Item 7) up against the back of the array enclosure and secure the clip
Figure 44, Item 3) on the latch bracket (1), using the alignment holes (2) as a
Figure 45, Item 1). Drop the lower corner mounting hole onto the lower
Figure 47) to the cabinet power distribution units (PDUs).
Figure 48, Item 1) to switch on the cabinet power. The cabinet
Table 18
Figure 46).
(Figure 42,
for ear standard clip