Display Module-Hp-Qualified Personnel Only - HP Surestore Disk Array 12h - And FC60 Service Manual

Removal and Replacement
Display Module–HP-qualified personnel only
Display Module–HP-qualified personnel only
CAUTION! The following procedures require that you perform a shutdown, turn off the
disk array, and make it inaccessible. Check with the system administrator before
proceeding.
To replace the display module(see
1. Shut down the disk array, turn off the disk array, disconnect the ac power cords and SCSI interface
cables.
2. Remove the two captive screws from the rear cover. Tilt back the top of the rear cover and remove it
completely.
3. Remove the two T-15 M4 Screws
assembly.
4. Remove both controller modules from the enclosure.
5. Remove the display module from the front of the disk array.
194
Figure 32):
(Figure 32, Item 3) that secure the display module to the backplane