Cabling The Storeeasy System To The Network - HP StoreEasy 1X60 Series Quick Start Manual

Figure 4: Cable management with tie wraps
6. Connect all power cords to the facility power source.

3. Cabling the StoreEasy system to the network

The iLO network port is used to remotely manage the StoreEasy 1X60 hardware and allows administrators to
launch a remote console session to the system. HPE recommends that you connect the iLO port to your
management network. The iLO port is preconfigured to obtain an IP address through DHCP. If your
environment does not support DHCP, use a KVM and configure iLO to use a static IP address. For
instructions, see HPE StoreEasy 1X60 Storage System Administrator Guide available at
https://support.hpe.com/hpesc/public/home/documentHome?sp4ts.oid=1008632547.
The 4 x 1GbE network ports are used for the storage network and to connect the system to infrastructure
services such as, Active Directory, DNS, NTP, etc. The ports can be configured as segregated network ports
or a network team. Ensure that your switch is prepared for either configuration.
Figure 5: Rear view of the StoreEasy 1660 and StoreEasy 1860 Storage system
1
2
If you have purchased additional interface cards for your StoreEasy 1X60, the following table guides you on
where to install them. The numerical values indicate the order of installation.
2 1
Network Ports
iLO Port
3. Cabling the StoreEasy system to the network 9