Table of Contents
Advertisement
WARNING!
To reduce the risk of electric shock or damage to the equipment, do not connect the power cord to the
power supply until the power supply is installed.
1.
Remove the protective cover from the connector pins on the power supply.
2.
Slide the power supply into the bay until it clicks.
Figure 76 Installing an AC power supply
3.
Use the strain relief clip to secure the power cord
Figure 77 Placing the power cord in the strain relief clip
4.
Connect the power cord to the power supply.
5.
Be sure that the power supply LED is green.
Power supply zone fan module
CAUTION:
Do not operate the node for long periods without the access panel. Operating the node without the
access panel results in improper airflow and improper cooling that can lead to thermal damage.
1.
Power off the node. See
2.
Extend or remove the node from the rack. See
3.
Remove the access panel. See
4.
Remove the SATA cable from the cable clip to avoid damaging the cable.
134
Component replacement
Powering off the
system.
Extending the node from the
Removing the VLS node access
(Figure
77).
panel.
rack.
Advertisement
Table of Contents
