Static Rp Configuration - Dell PowerConnect 6224 User Manual

Table 12-36. PIM Candidate RP Configuration Commands
CLI Command
ipv6 pimsm rp-candidate
Adding a Candidate RP
Use the Add Candidate RP page to add PIM Candidate rendezvous points (RPs) for each IP multicast
group.
1. Open the Candidate RP Configuration page.
2. Click Add.
The Add Candidate RP page displays.
Figure 12-38. Add Candidate RP
3. Select the interface for which the Candidate RP is to be configured.
4. Enter the group address transmitted in Candidate-RP-Advertisements.
5. Enter the prefix length transmitted in Candidate-RP-Advertisements to fully identify the scope of the
group which the router supports if elected as a Rendezvous Point.
6. Click Apply Changes.
The new Candidate RP is added, and the device is updated.

Static RP Configuration

Use the PIM Static RP Configuration page to display or remove the configured RP. The page also allows
adding new static RPs by clicking the Add button.
To access the page, click IPv4 Multicast → PIM → Static RP Configuration or IPv6 Multicast → PIM →
Static RP Configuration.
Description
Configures the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Configuring IP Multicast
773