Pim Interface Configuration - Dell PowerConnect 6224 User Manual

Admin Mode — Displays the administrative status of the selected PIM protocol on the system.
•
• Data Threshold Rate — If PIM-SM is selected as the protocol, shows the minimum source data rate in
Kbps above which the last-hop router switches to a source-specific shortest path tree.
• Register Threshold Rate — If PIM-SM is selected as the protocol, shows the minimum source data
rate in Kbps above which the Rendezvous Point router switches to a source-specific shortest path tree.
Viewing Global PIM Settings Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• PIM-DM or PIM-SM Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 12-33. PIM Global Settings Summary Commands
CLI Command
show ip pimdm
show ip pimsm

PIM Interface Configuration

Use the PIM Interface Configuration page to configure specific interfaces with PIM.
To display the page, click IPv4 Multicast → PIM → Interface Configuration or IPv6 Multicast → PIM →
Interface Configuration in the tree view.
Figure 12-35. PIM Interface Configuration
The PIM Interface Configuration page contains the following fields:
768
Configuring IP Multicast
Description
Displays system-wide information for PIM-DM.
Displays the system-wide information for PIM-SM.