Dell PowerConnect 6224 User Manual page 141

The Remote Log Server Settings page contains the following fields:
• Log Server — Server to which logs can be sent.
• UDP Port (1 65535) — Sets the UDP port from which the logs are sent. The default value is 514.
–
• Facility — A user-defined application from which system logs are sent to the remote server. Only one
facility can be assigned to a single server. If a second facility level is assigned, the first facility level is
overridden. All applications defined for a device use the same facility on a server. The possible field
values are from Local 0 to Local 7.
• Description — Sets the server description. The maximum length is 64 characters.
• Severity — Selects the log severity. Selecting a severity level automatically selects all higher severity
levels.
• Remove Log Server — Removes a server from the Log Server list. Checking the check box removes the
server from the list. Leaving the box unchecked maintains the server in the list.
The Remote Log Server Settings page also contains a severity list. The severity definitions are the same
as the severity definitions on the RAM Log Table page.
Sending Logs to a Server
1. Open the Remote Log Server Settings page.
2. Define the UDP Port, Facility, and Description fields.
3. Select the log type and log severity by using the Log Parameters check boxes.
NOTE: When you select a severity level, all higher severity levels are automatically selected.
4. Click Apply Changes.
The log settings are saved, and the device is updated.
Adding a New Server
1. Open the Remote Log Server Settings page.
2. Click Add to display the Add Remote Log Server page.
NOTE: Before adding a new server, determine the IP address of the remote log server.
Configuring System Information
141