Ssm Range Configuration - Dell PowerConnect 6224 User Manual

Figure 12-40. Add Static RP
3. Enter the IP address of the RP for the group range.
4. Enter the group address of the RP.
5. Enter the group mask of the RP.
6. Check the Override option to configure the static RP to override the dynamic (candidate) RPs learned
for same group ranges.
7. Click Apply Changes.
The new Static RP is added, and the device is updated.
Configuring the Candidate RP Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• PIM Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 12-37. PIM Candidate RP Configuration Commands
CLI Command
ipv6 pimsm rp-address

SSM Range Configuration

Use this page to display or remove the the Source Specific Multicast (SSM) group IP address and group
mask for the PIM router.
To display the page, click IPv4 Multicast → PIM → SSM Range Configuration or IPv6 Multicast → PIM
→ SSM Candidate Configuration.
Description
Statically configures the RP address for one or more multicast groups.
Configuring IP Multicast
775