Mld Routing Interface Summary - Dell PowerConnect 6224 User Manual

Query Interval — Specify the number of seconds between MLD general queries. Valid values are 1 to
•
3600. The default value is 125.
Query Max Response Time (secs) — Enter the maximum query response time to be advertised in
•
MLDv2 queries on this interface, in ms. The default value is 10000. Valid values are 0 to 65535
milliseconds (ms).
Last Member Query Interval — Enter the maximum response time inserted into group-specific
•
queries sent in response to leave group messages. This value is also the amount of time between group-
specific query messages. This value may be tuned to modify the leave latency of the network. Valid
values are 0 to 65535 milliseconds (ms). The default is 1000.
• Last Member Query Count — The number of queries to be sent on receiving a leave group report.
Valid values are 1 to 20. The default is 2.
Configuring MLD Routing Interfaces Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• IPv6 Routing Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 12-24. IPv6 MLD Routing Interface Commands
CLI Command
ipv6 mld last-member-query-count
ipv6 mld last-member-query-interval
ipv6 mld query-interval
ipv6 mld query-max-response-time
ipv6 mld router

MLD Routing Interface Summary

Use the MLD Routing Interface Summary page to display information and statistics on a selected
MLD-enabled interface. You must configure at least one IGMP router interface to access this page.
To access this page, click IPv6 Multicast → MLD → Routing Interface → Interface Summary in the
navigation tree.
Description
Sets the number of listener-specific queries sent before the router
assumes that there are no local members on the interface.
Sets the last member query interval for the MLD interface, which is
the value of the maximum response time parameter in the
groupspecific queries sent out of this interface.
Sets the MLD router's query interval for the interface.
Sets MLD querier's maximum response time for the interface.
Enables MLD in the router in global configuration mode and for a
specific interface in interface configuration mode.
Configuring IP Multicast
753