Protocol Group - Dell PowerConnect 6224 User Manual

Binding IP Subnets to VLANs Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• VLAN Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-30. IP Subnet - VLAN Binding Commands
CLI Command
vlan association subnet
show vlan association subnet

Protocol Group

In a protocol-based VLAN, traffic is bridged through specified ports based on the VLAN's protocol. User-
defined packet filters determine if a particular packet belongs to a particular VLAN. Protocol-based
VLANs are most often used in situations where network segments contain hosts running multiple
protocols.
Use the Protocol Group page to configure which EtherTypes go to which VLANs, and then enable
certain ports to use these settings.
To display the Protocol Group page, click Switching → VLAN → Protocol Group in the tree view.
Description
Associates an IP subnet to a VLAN
Displays the VLAN associated with a specific configured IP subnet.
Configuring Switching Information
375