Disable — Uses the configuration file as the running configuration only. When the switch reboots,
–
it will load the configuration from the startup configuration file.
Retry Count — Indicates the number of times to attempt the auto configuration process during boot
•
up. The number of times the switch has attempted to contact the TFTP server during the current
Auto Configuration session.
Auto Configuration State — Shows the current state of the Auto Configuration process.
•
Configuring Auto Configuration Using CLI Commands
For information about the CLI commands that perform this function, see the Utility Commands - Auto
Config chapter in the
commands you use to configure Auto Configuring.
Table 6-52. Auto Configuration Commands
CLI Command
boot host auto-save
boot host dhcp
boot host retry-count
show boot
248
Configuring System Information
CLI Reference Guide
. The following table summarizes the equivalent CLI
Description
Enables/disables automatically saving the downloaded configuration
on the switch.
Enables/disables Auto Config on the switch.
Set the number of attempts to download a configuration.
Displays the current status of the Auto Config process.