Dell PowerConnect 6224 User Manual page 562

Global Route Changes — Displays the number of route changes made to the IP Route Database by
•
RIP. This does not include the refresh of a route's age.
Global Queries — Displays the number of responses sent to RIP queries from other systems.
•
• Default Information Originate — Enable or Disable Default Route Advertise.
• Default Metric — Sets a default for the metric of redistributed routes.This field displays the default
metric if one has already been set, or blank if not configured earlier. Valid values are 1 to 15.
Configuring RIP
1. Open the RIP Configuration page.
2. Enter data in the fields as needed.
3. Click Apply Changes when finished.
RIP is configured, and the device is updated.
Configuring RIP Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• Routing Information Protocol (RIP) Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-25. RIP Global Configuration Commands
CLI Command
auto-summary
default-information originate
default-metric
distance rip
enable
hostroutesaccept
router rip
show ip rip
split-horizon
562
Configuring Routing
Description
Enables the RIP auto-summarization mode.
Controls the advertisement of default routes.
Sets a default for the metric of distributed routes.
Sets the route preference value of RIP in the router.
Resets the default administrative mode of RIP in the router (active).
Enables the RIP hostroutesaccept mode.
Enters Router RIP mode.
Displays information relevant to the RIP router.
Sets the RIP split horizon mode.