Bay 1 And Bay 2 Interfaces; Serial Cable Connection; Connecting The Switch To A Terminal - Dell PowerConnect 6224 User Manual

Bay 1 and Bay 2 Interfaces

The Dell™ PowerConnect™ 6200series switches support dual 10 Gb slot interfaces. These interfaces can
operate at 10 Gbps when supporting optional SFP+, CX4, XFP , and 10GBase-T modules.
Figure 3-3. Bay 1 and Bay 2 PowerConnect 6200 Series 10 Gb Slots

Serial Cable Connection

You can use the supplied serial cable (null-modem) to connect the switch to a terminal for initial setup
and configuration (You can also use a computer running terminal emulation software). The switch's
serial cable is a female to female DB-9 crossover cable.

Connecting the Switch to a Terminal

1. Connect the serial cable to the terminal (console) ASCII DTE RS-232.
2. Connect the serial cable to the switch's serial port.
3. If you are configuring a stack, connect the interface cable to the serial port of the Master switch.
Figure 3-4. Serial Connection to Switch
52
Cable and Port Information
Serial Connector to Console