Figure 7-94. LLDP Configuration
The LLDP Configuration page contains the following fields:
Global Settings
•
Transmit Interval (1–32768) — Specifies the interval at which frames are transmitted. The default is
30 seconds.
•
Hold Multiplier (2–10) — Specifies multiplier on the transmit interval to assign to TTL. Default is 4.
•
Re-Initialization Delay (1–10) — Specifies delay before a re-initialization. Default is 2 seconds.
Notification Interval (5–3600) — Limits the transmission of notifications. The default is 5 seconds.
•
Port Settings
•
Interface — Specifies the port to be affected by these parameters.
•
Transmit Mode — Enables or disables the transmit function. The default is disabled.
•
Receive Mode — Enables or disables the receive function. The default is disabled.
Transmit Management Information — Enables or disables transmission of management address
•
instance. Default is disabled.
•
Notification Mode — Enables or disables remote change notifications. The default is disabled.
418
Configuring Switching Information