Dell PowerConnect 6224 User Manual page 741

Version 1 Host Timer — The time remaining until the local router assumes that there are no longer
•
any IGMP version 1 members on the IP subnet attached to this interface. When an IGMPv1
membership report is received, this timer is reset to the group membership timer. While this timer is
non-zero, the local router ignores any IGMPv2 leave messages for this group that it receives on the
selected interface. This field is displayed only if the interface is configured for IGMP version 1.
• Version 2 Host Timer — The time remaining until the local router assumes that there are no longer
any IGMP version 2 members on the IP subnet attached to this interface. When an IGMPv2
membership report is received, this timer is reset to the group membership timer. While this timer is
non-zero, the local router ignores any IGMPv1 and IGMPv3 leave messages for this group that it
receives on the selected interface. This field is displayed only if the interface is configured for IGMP
version 2.
• Compatibility — This parameter shows group compatibility mode (v1, v2 and v3) for this group on
the specified interface.
• Filter Mode — The source filter mode (Include/Exclude/NA) for the specified group on this interface.
When NA mode is active the field is blank.
Displaying Cache Information Using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• IGMP Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 12-17. IGMP Cache Information Command
CLI Command
show ip igmp groups
IGMP Interface
Use the IGMP Interface page to display detailed membership information for an interface. You must
configure at least one IGMP router interface to access this page. Also, group membership reports must
have been received on the selected interface for data to display here.
To display the page, click IPv4 Multicast → IGMP → Routing Interface → in the tree view.
Description
Displays the registered multicast groups on the interface.
Configuring IP Multicast
741