Dell PowerConnect 6224 User Manual page 106

Powerconnect 6200 series

Hide thumbs Also See for PowerConnect 6224:

Table of Contents

Figure 5-3. HyperTerminal Properties Window

NOTE: 9600 is the default baud rate for a new switch. The switch may have another baud rate. If using the

default baud rate does not result in viewing the switch terminal, try another baud rate.

3. Use F2F null modem cable to connect the workstation to the switch.

If you are configuring a

4. Connect the switch power cord and power up the switch. The system begins the boot process. When

the following displays, you can enter the Boot menu by selecting 2, if necessary, to run special

Select an option. If no selection in 10 seconds then operational code

1 - Start operational code.

2 - Start Boot Menu.

Select (1, 2):2

If you do not enter the Boot menu, the system continues operation by decompressing the code into

RAM. The code starts running from the RAM and the list of available port numbers and their states (up

or down) are displayed.

NOTE: The following screen is an example configuration. Items such as addresses, versions, and dates may differ

for each switch.

Configuring Dell PowerConnect

, connect the workstation to the Master Switch.

Show Quick Links

Table of Contents