Dhcpv6 Pool Configuration - Dell PowerConnect 6224 User Manual

The DHCPv6 Global Configuration page contains the following fields:
• DHCPv6 Admin Mode — Specifies DHCPv6 operation on the switch. Possible values are Enable and
Disable; the default value is Disable.
• Relay Option — Specifies Relay Agent Information Option value. The values allowed are between 32
to 65535, and represent the value exchanged between the relay agent and the server. Each value has a
different meaning, of which 1 to 39 are standardized. The default value, 32, means
OPTION_INFORMATION_REFRESH_TIME.
Remote-id Sub-option — Lets you specify a number to represent the Relay Agent Information Option
•
Remote-ID Sub-option type. The values allowed are between 1 and 65535. The default value is 1.
Configuring DHCPv6 Global Parameters
1. Open the DHCPv6 Global Configuration page.
2. Modify the fields as needed.
3. Click Apply Changes.
The DHCPv6 parameter modifications are saved, and the device is updated.
Configuring DHCPv6 Global Parameters Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• DHCPv6 Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 10-6. DHCPv6 Global Commands
CLI Command
service dhcpv6
show ipv6 dhcp

DHCPv6 Pool Configuration

DHCP for IPv6 clients are connected to a server which is configured to use parameters from a pool that
you set up. The pool is identified with a pool name, and contains IPv6 addresses and domain names of
DNS servers.
Use the Pool Configuration page to create a pool and/or configure pool parameters.
To display the page, click IPv6 → DHCPv6 → Pool Configuration in the tree view.
Description
Enables DHCPv6 configuration on the router.
Displays the DHCPv6 server name and status.
625
Configuring IPv6