Dell PowerConnect 6224 User Manual page 722

To display the page, click IPv4 Multicast → Multicast → Static MRoute Configuration in the tree view.
Figure 12-6. Multicast Static Routes Configuration
The Multicast Static MRoute Configuration page contains the following fields:
• Source IP — Enter the IP Address that identifies the multicast packet source for the entry you are
creating.
• Source Mask — Enter the subnet mask to be applied to the Source IP address.
• RPF Next Hop— Enter the IP address of the neighbor router on the path to the source.
• Preference — Enter the preference with which the static mroute to be considered against other
matching static mroute entry for a given source. The values should range from 1 to 255.
Configuring a Static Route
1. Open the Static Routes page.
2. Modify the fields as needed.
3. Click Apply Changes.
The new or modified static route is saved, and the device is updated.
Configuring a Static Route the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• Multicast Commands
The following table summarizes the equivalent CLI commands for this feature.
722
Configuring IP Multicast