Cisco WS-CBS3032-DEL Software Configuration Manual page 888

Configuring Standard QoS
Command
Step 13
police rate-bps burst-byte [exceed-action
{drop | policed-dscp-transmit}]
Step 14
exit
Step 15
exit
Step 16 policy-map policy-map-name
Step 17 class [class-map-name | class-default]
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
37-68
Purpose
Defines an individual policer for the classified traffic.
By default, no policer is defined. For information on the number of
policers supported, see the
section on page 37-38.
For rate-bps, specify average traffic rate in bits per second (b/s).
•
The range is 8000 to 10000000000.
For burst-byte, specify the normal burst size in bytes. The range is
•
8000 to 1000000.
(Optional) Specify the action to take when the rates are exceeded.
•
Use the exceed-action drop keywords to drop the packet. Use the
exceed-action policed-dscp-transmit keywords to mark down the
DSCP value (by using the policed-DSCP map) and to send the
packet. For more information, see the
Policed-DSCP Map" section on page
Returns to policy-map configuration mode.
Returns to global configuration mode.
Creates a VLAN-level policy map by entering the policy-map name,
and enter policy-map configuration mode.
By default, no policy maps are defined.
The default behavior of a policy map is to set the DSCP to 0 if the
packet is an IP packet and to set the CoS to 0 if the packet is tagged. No
policing is performed.
Defines a VLAN-level traffic classification, and enter policy-map class
configuration mode.
By default, no policy-map class-maps are defined.
If a traffic class has already been defined by using the class-map global
configuration command, specify its name for class-map-name in this
command.
A class-default traffic class is pre-defined and can be added to any
policy. It is always placed at the end of a policy map. With an implied
match any included in the class-default class, all packets that have not
already matched the other traffic classes will match class-default.
Chapter 37
"Standard QoS Configuration Guidelines"
"Configuring the
37-77.
Configuring QoS
OL-13270-06