Table of Contents
Advertisement
Configuring IP Source Guard
Command
Step 3
ip verify source
or
ip verify source port-security
Step 4
exit
Step 5
ip source binding mac-address vlan
vlan-id ip-address inteface interface-id
Step 6
end
Step 7
show ip verify source [interface
interface-id]
Step 8
show ip source binding [ip-address]
[mac-address] [dhcp-snooping | static]
[inteface interface-id] [vlan vlan-id]
Step 9
copy running-config startup-config
To disable IP source guard with source IP address filtering, use the no ip verify source interface
configuration command.
To delete a static IP source binding entry, use the no ip source global configuration command.
This example shows how to enable IP source guard with source IP and MAC filtering on VLANs 10
and 11:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip verify source port-security
Switch(config-if)# exit
Switch(config)# ip source binding 0100.0022.0010 vlan 10 10.0.0.2 interface
gigabitethernet1/0/1
Switch(config)# ip source binding 0100.0230.0002 vlan 11 10.0.0.4 interface
gigabitethernet1/0/1
Switch(config)# end
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
22-20
Chapter 22
Purpose
Enable IP source guard with source IP address filtering.
Enable IP source guard with source IP and MAC address filtering.
When you enable both IP Source Guard and Port Security by
Note
using the ip verify source port-security interface configuration
command, there are two caveats:
The DHCP server must support option 82, or the client is not
•
assigned an IP address.
•
The MAC address in the DHCP packet is not learned as a secure
address. The MAC address of the DHCP client is learned as a
secure address only when the switch receives non-DHCP data
traffic.
Return to global configuration mode.
Add a static IP source binding.
Enter this command for each static binding.
Return to privileged EXEC mode.
Display the IP source guard configuration for all interfaces or for a
specific interface.
Display the IP source bindings on the switch, on a specific VLAN, or on
a specific interface.
(Optional) Save your entries in the configuration file.
Configuring DHCP Features and IP Source Guard
OL-13270-06
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
