Default Protected Port Configuration; Protected Port Configuration Guidelines; Configuring A Protected Port - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 26 Configuring Port-Based Traffic Control
These sections contain this configuration information:
•
•
•

Default Protected Port Configuration

The default is to have no protected ports defined.

Protected Port Configuration Guidelines

You can configure protected ports on a physical interface (for example, Gigabit Ethernet port 1) or an
EtherChannel group (for example, port-channel 5). When you enable protected ports for a port channel,
it is enabled for all ports in the port-channel group.
Do not configure a private-VLAN port as a protected port. Do not configure a protected port as a
private-VLAN port. A private-VLAN isolated port does not forward traffic to other isolated ports or
community ports. For more information about private VLANs, see
VLANs."

Configuring a Protected Port

Beginning in privileged EXEC mode, follow these steps to define a port as a protected port:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 switchport protected
Step 4
end
Step 5
show interfaces interface-id switchport
Step 6 copy running-config startup-config
To disable protected port, use the no switchport protected interface configuration command.
This example shows how to configure a port as a protected port:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport protected
Switch(config-if)# end
OL-13270-06
Default Protected Port Configuration, page 26-7
Protected Port Configuration Guidelines, page 26-7
Configuring a Protected Port, page 26-7
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface
configuration mode.
Configure the interface to be a protected port.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring Protected Ports
Chapter 16, "Configuring Private
26-7