Cisco WS-CBS3032-DEL Software Configuration Manual page 1132

Configuring WCCP
Command
Step 6
no shutdown
Step 7
exit
Step 8 interface interface-id
Step 9 no switchport
Step 10 ip address ip-address subnet-mask
Step 11
no shutdown
Step 12
ip wccp {web-cache | service-number} redirect in Redirect packets received from the client to the application
Step 13 ip wccp {web-cache | service-number}
group-listen
Step 14
exit
Step 15
end
Step 16 show ip wccp web-cache
and
show running-config
Step 17 copy running-config startup-config
To disable the cache service, use the no ip wccp web-cache global configuration command. To disable
inbound packet redirection, use the no ip wccp web-cache redirect in interface configuration command.
After completing this procedure, configure the application engines in the network.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
44-8
Chapter 44
Purpose
Enable the interface.
Return to global configuration mode. Repeat Steps 3 through 7
for each application engine and server.
Specify the interface connected to the client, and enter
interface configuration mode.
Enter Layer 3 mode.
Configure the IP address and subnet mask.
Enable the interface.
engine. Enable this on the interface connected to the client.
(Optional) When using a multicast group address, group-listen
enables the interface to listen for the multicast address. Enable
this on the interface connected to the application engine.
Return to global configuration mode. Repeat Steps 8 through
13 for each client.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring Cache Services By Using WCCP
OL-13270-06