Uploading A Configuration File By Using Rcp - Cisco WS-CBS3032-DEL Software Configuration Manual

Appendix A Working with the Cisco IOS File System, Configuration Files, and Software Images
Command
Step 5
end
Step 6
copy
rcp:[[[//[username@]location]/directory]/filename]
system:running-config
or
copy
rcp:[[[//[username@]location]/directory]/filename]
nvram:startup-config
This example shows how to copy a configuration file named host1-confg from the netadmin1 directory
on the remote server with an IP address of 172.16.101.101 and load and run those commands on the
switch:
Switch# copy rcp://netadmin1@172.16.101.101/host1-confg system:running-config
Configure using host1-confg from 172.16.101.101? [confirm]
Connected to 172.16.101.101
Loading 1112 byte file host1-confg:![OK]
Switch#
%SYS-5-CONFIG: Configured from host1-config by rcp from 172.16.101.101
This example shows how to specify a remote username of netadmin1. Then it copies the configuration
file host2-confg from the netadmin1 directory on the remote server with an IP address of 172.16.101.101
to the startup configuration:
Switch# configure terminal
Switch(config)# ip rcmd remote-username netadmin1
Switch(config)# end
Switch# copy rcp: nvram:startup-config
Address of remote host [255.255.255.255]? 172.16.101.101
Name of configuration file[rtr2-confg]? host2-confg
Configure using host2-confg from 172.16.101.101?[confirm]
Connected to 172.16.101.101
Loading 1112 byte file host2-confg:![OK]
[OK]
Switch#
%SYS-5-CONFIG_NV:Non-volatile store configured from host2-config by rcp from
172.16.101.101

Uploading a Configuration File By Using RCP

Beginning in privileged EXEC mode, follow these steps to upload a configuration file by using RCP:
Command
Step 1
Step 2
Step 3 configure terminal
OL-13270-06
Purpose
Return to privileged EXEC mode.
Using RCP, copy the configuration file from a network
server to the running configuration or to the startup
configuration file.
Purpose
Verify that the RCP server is properly configured by
referring to the
Configuration File By Using RCP" section on page
Log into the switch through the console port, the Ethernet
management port, or a Telnet session.
Enter global configuration mode.
This step is required only if you override the default remote
username (see Steps 4 and 5).
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Working with Configuration Files
"Preparing to Download or Upload a
A-18.
A-19