Configuring Spanning-Tree Timers; Configuring The Hello Time - Cisco WS-CBS3032-DEL Software Configuration Manual

Configuring Spanning-Tree Features

Configuring Spanning-Tree Timers

Table 18-4
Table 18-4 Spanning-Tree Timers
Variable Description
Hello timer Controls how often the switch broadcasts hello messages to other switches.
Forward-delay timer Controls how long each of the listening and learning states last before the interface begins
forwarding.
Maximum-age timer Controls the amount of time the switch stores protocol information received on an interface.
Transmit hold count Controls the number of BPDUs that can be sent before pausing for 1 second.
The sections that follow provide the configuration steps.

Configuring the Hello Time

You can configure the interval between the generation of configuration messages by the root switch by
changing the hello time.
Exercise care when using this command. For most situations, we recommend that you use the
Note
spanning-tree vlan vlan-id root primary and the spanning-tree vlan vlan-id root secondary global
configuration commands to modify the hello time.
Beginning in privileged EXEC mode, follow these steps to configure the hello time of a VLAN. This
procedure is optional.
Command
Step 1
configure terminal
Step 2 spanning-tree vlan vlan-id hello-time seconds
Step 3 end
Step 4
show spanning-tree vlan vlan-id
Step 5 copy running-config startup-config
To return to the default setting, use the no spanning-tree vlan vlan-id hello-time global configuration
command.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
18-22
describes the timers that affect the entire spanning-tree performance.
Purpose
Enter global configuration mode.
Configure the hello time of a VLAN. The hello time is the
interval between the generation of configuration messages by
the root switch. These messages mean that the switch is alive.
• For vlan-id, you can specify a single VLAN identified by
VLAN ID number, a range of VLANs separated by a
hyphen, or a series of VLANs separated by a comma. The
range is 1 to 4094.
For seconds, the range is 1 to 10; the default is 2.
•
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 18 Configuring STP
OL-13270-06