Uploading The Configuration File By Using Tftp - Cisco WS-CBS3032-DEL Software Configuration Manual

Appendix A Working with the Cisco IOS File System, Configuration Files, and Software Images
Use one of these privileged EXEC commands:
•
•
•
Note
The configuration file downloads, and the commands are executed as the file is parsed line-by-line.
This example shows how to configure the software from the file tokyo-confg at IP address 172.16.2.155:
Switch# copy tftp:/172.16.2.155/tokyo-confg system:running-config
Configure using tokyo-confg from 172.16.2.155? [confirm] y
Booting tokyo-confg from 172.16.2.155:!!! [OK - 874/16000 bytes]

Uploading the Configuration File By Using TFTP

To upload a configuration file from a switch to a TFTP server for storage, follow these steps:
Verify that the TFTP server is properly configured by referring to the
Step 1
a Configuration File By Using TFTP" section on page
Log into the switch through the console port, the Ethernet management port, or a Telnet session.
Step 2
Upload the switch configuration to the TFTP server. Specify the IP address or hostname of the TFTP
Step 3
server and the destination filename.
Use one of these privileged EXEC commands:
•
•
•
Note
The file is uploaded to the TFTP server.
This example shows how to upload a configuration file from a switch to a TFTP server:
Switch# copy system:running-config tftp://172.16.2.155/tokyo-confg
Write file tokyo-confg on host 172.16.2.155? [confirm] y
#
Writing tokyo-confg!!! [OK]
OL-13270-06
copy tftp:[[[//location]/directory]/filename] system:running-config
copy tftp:[[[//location]/directory]/filename] nvram:startup-config
copy tftp:[[[//location]/directory]/filename] flash[n]:/directory/startup-config
You can only enter the flashn parameter (for example, flash3) on stacking-capable switches.
copy system:running-config tftp:[[[//location]/directory]/filename]
copy nvram:startup-config tftp:[[[//location]/directory]/filename]
copy flash[n]:/directory/startup-config tftp:[[[//location]/directory]/filename]
You can only enter the flashn parameter (for example, flash3) on Catalyst 3750-E switches.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Working with Configuration Files
"Preparing to Download or Upload
A-12.
A-13