Default Rip Configuration - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 39 Configuring IP Unicast Routing
These sections contain this configuration information:
•
•
•
•

Default RIP Configuration

Table 39-4
Table 39-4
Feature
Auto summary
Default-information originate
Default metric
IP RIP authentication key-chain No authentication.
IP RIP receive version
IP RIP send version
IP RIP triggered
IP split horizon
Neighbor
Network
Offset list
Output delay
Timers basic
Validate-update-source
Version
OL-13270-06
Default RIP Configuration, page 39-21
Configuring Basic RIP Parameters, page 39-22
Configuring RIP Authentication, page 39-23
Configuring Summary Addresses and Split Horizon, page 39-24
shows the default RIP configuration.
Default RIP Configuration
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Default Setting
Enabled.
Disabled.
Built-in; automatic metric translations.
Authentication mode: clear text.
According to the version router configuration command.
According to the version router configuration command.
According to the version router configuration command.
Varies with media.
None defined.
None specified.
Disabled.
0 milliseconds.
Update: 30 seconds.
•
Invalid: 180 seconds.
•
Hold-down: 180 seconds.
•
Flush: 240 seconds.
•
Enabled.
Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Configuring RIP
39-21