Ip Multicast Routing; Unsupported Privileged Exec Commands; Unsupported Global Configuration Commands - Cisco WS-CBS3032-DEL Software Configuration Manual

Appendix B Unsupported Commands in Cisco IOS Release 12.2(58)SE

IP Multicast Routing

Unsupported Privileged EXEC Commands

clear ip rtp header-compression [type number]
The debug ip packet command displays packets received by the switch CPU. It does not display packets
that are hardware-switched.
The debug ip mcache command affects packets received by the switch CPU. It does not display packets
that are hardware-switched.
The debug ip mpacket [detail] [access-list-number [group-name-or-address] command affects only
packets received by the switch CPU. Because most multicast packets are hardware-switched, use this
command only when you know that the route will forward the packet to the CPU.
debug ip pim atm
show frame-relay ip rtp header-compression [interface type number]
The show ip mcache command displays entries in the cache for those packets that are sent to the switch
CPU. Because most multicast packets are switched in hardware without CPU involvement, you can use
this command, but multicast packet information is not displayed.
The show ip mpacket commands are supported but are only useful for packets received at the switch
CPU. If the route is hardware-switched, the command has no effect because the CPU does not receive
the packet and cannot display it.
show ip pim vc [group-address | name] [type number]
show ip rtp header-compression [type number] [detail]

Unsupported Global Configuration Commands

ip pim accept-rp {address | auto-rp} [group-access-list-number]
ip pim message-interval seconds
OL-13270-06
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
IP Multicast Routing
B-7