Configuring An Fspan Session - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 30 Configuring SPAN and RSPAN
•
•
Note
•
•
•
•

Configuring an FSPAN Session

Beginning in privileged EXEC mode, follow these steps to create a SPAN session, specify the source
(monitored) ports or VLANs and the destination (monitoring) ports, and configure FSPAN for the
session:
Command
Step 1 configure terminal
Step 2
no monitor session {session_number | all |
local | remote}
OL-13270-06
VLAN-based FSPAN sessions cannot be configured on a stack that includes Catalyst 3750 switches.
FSPAN ACLs cannot be applied to per-port-per-VLAN sessions. You can configure
per-port-per-VLAN sessions by first configuring a port-based session and then configuring specific
VLANs to the session. For example:
Switch (config)# monitor session session_number source interface interface-id
Switch (config)# monitor session session_number filter vlan vlan-id
Switch (config)# monitor session session_number filter ip access-group
(access-list-number | name}
Both the filter vlan and filter ip access-group commands cannot be configured at the same time.
Configuring one results in rejection of the other.
EtherChannels are not supported in an FSPAN session.
FSPAN ACLs with TCP flags or the log keyword are not supported.
If you configure an IPv6 FSPAN ACL when the switch is running the advanced IP services feature
set but later run a different feature set, after rebooting the switch, the switch might lose the IPv6
FSPAN ACL configuration.
IPv6 FSPAN ACLs are supported only on IPv6-enabled SDM templates. If you configure an IPv6
FSPAN ACL when running an IPv6 enabled SDM template, but later configure a non-IPv6 SDM
template and reboot the switch, you lose the IPv6 FSPAN ACL configuration.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Purpose
Enter global configuration mode.
Remove any existing SPAN configuration for the session.
For session_number, the range is 1 to 66.
Specify all to remove all SPAN sessions, local to remove all local
sessions, or remote to remove all remote SPAN sessions.
Configuring FSPAN and FRSPAN
30-25