C H A P T E R 32 Configuring System Message Logging - Cisco WS-CBS3032-DEL Software Configuration Manual

Chapter 32 Configuring System Message Logging
Table 32-1
Table 32-1 System Log Message Elements
Element
seq no:
timestamp formats:
mm/dd hh:mm:ss
or
hh:mm:ss (short uptime)
or
d h (long uptime)
facility
severity
MNEMONIC
description
hostname-n
This example shows a partial switch system message for a stack master and a stack member (hostname
Switch-2):
00:00:46: %LINK-3-UPDOWN: Interface Port-channel1, changed state to up
00:00:47: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/1, changed state to up
00:00:47: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/2, changed state to up
00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/1, changed
state to down 2
*Mar
18:47:02: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
*Mar
00:00:46: %LINK-3-UPDOWN: Interface Port-channel1, changed state to up (Switch-2)
00:00:47: %LINK-3-UPDOWN: Interface GigabitEthernet2/0/1, changed state to up (Switch-2)
00:00:47: %LINK-3-UPDOWN: Interface GigabitEthernet2/0/2, changed state to up (Switch-2)
00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
(Switch-2)
00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet2/0/1, changed
state to down 2 (Switch-2)
OL-13270-06
describes the elements of syslog messages.
Description
Stamps log messages with a sequence number only if the service sequence-numbers global
configuration command is configured.
For more information, see the
section on page 32-8.
Date and time of the message or event. This information appears only if the service timestamps
log [datetime | log] global configuration command is configured.
For more information, see the
on page 32-8.
The facility to which the message refers (for example, SNMP, SYS, and so forth). For a list of
supported facilities, see Table 32-4 on page
Single-digit code from 0 to 7 that is the severity of the message. For a description of the severity
levels, see Table 32-3 on page
Text string that uniquely describes the message.
Text string containing detailed information about the event being reported.
Hostname of a stack member and its switch number in the stack. Though the stack master is a stack
member, it does not append its hostname to system messages.
1 18:46:11: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
1 18:48:50.483 UTC: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
"Enabling and Disabling Sequence Numbers in Log Messages"
"Enabling and Disabling Time Stamps on Log Messages" section
32-14.
32-10.
Configuring System Message Logging
32-3